Replacing Important Components; Instruction For The User; Igniting The Pilot Burner - Eurofrequence Minima Serie Instructions Pour L'installation, L'emploi Et L'entretien

4.
To be performed exclusively by authorised technical service!
In order to replace these components, it is important to first do the following:
- Shut off the gas supply outlet valve
- Remove the grease well drawer (18 Fig. 5)
- Disassemble the front panel with the thermostat knob (Fig. 5 positions 17 and 20)
- Remove the drawer guide.
A) Safety Valve/Thermostat (fig. 2)
- Unscrew the gas inlet (10) and outlet (13) connections with a size-19 spanner
- Unscrew the pilot burner inlet (15) with a size-10 spanner
- Unscrew the thermocouple (16) with a size-9 spanner
- Disassemble the bulb from its housing inside the plate (14)
- Lift off the cooking plate and place it on the ground
- Install the new thermostat
- Check the idle screw (bypass) (11); it should comply with Table II.
ATTENTION: make sure the bulb is positioned properly in the plate and check the gas sealing with bubble soap.
B) Thermocouple (fig. 1 and 2)
- Unscrew the thermocouple of the safety valve (16 Fig. 2) with a size-9 spanner
- Unscrew the nut (9) with a size-10 spanner
- Install the new thermocouple.
C) Spark plug (fig. 1)
- Detach the high-voltage wire from the spark plug (10)
- Unscrew the nut (7) with a size-10 spanner
- Install the new spark plug
- Connect the high-voltage wire.
D) Piezoelectric Igniter (fig. 5)
- Detach the high-voltage wire from the igniter
- Unscrew the nut behind the panel (19)
- Install the new piezoelectric igniter
- Mount back the grease well holder
- Mount back the front panel (17) and the knob (20)
- Replace the grease well drawer (18 Fig. 5)
- Position the plate and the bulb appropriately.
5.
5.1 IGNITING THE PILOT BURNER FIG. 3 AND 5
- To ignite the pilot burner, press the knob (20) turning it to the left to reach the symbol (
press the knob deeply down and at the same time push the piezoelectric ignition button (19).
- The pilot, visible through the peephole on the panel (21), will light up; keep the knob pressed for approx. 15 seconds and
then release it. Should the pilot go off, repeat the ignition operation.

REPLACING IMPORTANT COMPONENTS

INSTRUCTION FOR THE USER

- 19 -
); having reached this position,
GB