StreamLight TLR-6 Instructions D'utilisation page 5

SWITCH OPERATION
The TLR-6 features ambidextrous side switches that provide momentary or constant activation
®
and allows selection of the light/laser (laser models only).
• A tap on either switch turns the unit "on" or "off".
• Press and hold either switch for momentary activation of the unit.
• To cycle through the available modes (laser models only; Light, Laser, Light/Laser), press and
hold one switch and tap the other switch until desired mode is reached. The selected mode
will be saved when unit is turned "off".
• The TLR-6 will automatically turn itself off after 10 minutes of continuous operation to
®
conserve battery power.
TLR-6 LASER SIGHT ZEROING (Laser models only)
®
For a laser mounted below or to the side of the bore, there is only one distance where the bullet
path will coincide with the laser sight line. This point is the "zero range". Laser adjustment and
the muzzle velocity of the bullet determine where this point occurs. The user must decide how
high above or below the sight line the bullet can be allowed to strike and adjust the sight
accordingly. At distances less than the zero range the bullet will be above the sight line.
Beyond the zero range the bullet will be below the sight line.
There are two adjustment screws (mounted in bushings) located in the flashlight housing.
The windage adjustment is located on the left hand side of the housing. Turn the set screw
clockwise (use the included hex wrench) to move the laser to the left (POI right). Turn the set
screw counter-clockwise to move the laser to the right (POI left). The elevation adjustment is
located on the underside of the housing. With the TLR-6
of the adjustment screw will move the laser down (POI up). A counter-clockwise turn on the
adjustment screw will move the laser up (POI down). Move the laser dot in the direction that
the shots are hitting the target (example: If the bullets are striking low and right, move the
laser dot down and right to coincide with the bullet strike).
1/3N
Batteries
Switches
Laser Adjustment
(Laser models only)
pointed down range a clockwise turn
®