StreamLight TLR-6 Instructions D'utilisation page 4

FLASHLIGHT MOUNTING/REMOVAL
MAKE SURE THAT THE FIREARM IS UNLOADED AND THE BREECH IS OPEN.
IT IS IMPERATIVE THAT SAFETY MEASURES BE EMPLOYED AT ALL TIMES
WHILE HANDLING THE FIREARM.
The TLR-6 is designed to be attached to the trigger guard of the firearm.
®
Mounting/Assembly
Screws
1. Open battery door and remove any batteries (do not close door).
2. Use the hex wrench (included) to loosen and remove the 3 mounting/assembly screws.
3. Separate the two halves of the housing and retain the module.
4. Place the side of the housing (that has no battery door attached) on a flat, work surface.
5. Place the module into the molded surface and direct the LED toward the front opening.
6. Align the (unloaded firearm) trigger guard with the matching groove in the TLR-6
housing and place both onto the flat work surface.
7. Place the mating side of the TLR-6
TLR-6 (maintain alignment while joining the two halves together).
®
8. Securely fasten the two TLR-6
Note: Do not over tighten screws.
9. Reinstall batteries (maintain proper polarity/orientation) and secure the battery door.
BATTERY INSTALLATION/REMOVAL
MAKE SURE THAT THE FIREARM IS UNLOADED AND THE BREECH IS OPEN.
IT IS IMPERATIVE THAT SAFETY MEASURES BE EMPLOYED AT ALL TIMES
WHILE HANDLING THE FIREARM.
At the end of battery life, the switch may appear intermittent or non-functional.
Replacing the batteries will restore normal operation.
1. Unclip and swing battery door open.
2. Remove both depleted batteries from the flashlight body.
3. Insert fresh 1/3N batteries into the body of the TLR-6
Note: Batteries cannot have plastic wrapping.
4. Swing battery door shut and snap to lock.
Battery Door
over trigger guard and onto the other half of the
®
halves together with the 3 mounting/assembly screws.
®
Laser/LED Module
or LED Module
1/3N Batteries Only
(Non-Wrapped)
.
®
®