[Handlebar Handle Models] Installing Debris Shield - Maruyama B23L Manuel Du Propriétaire/De L'utilisateur

232025-04 12.11.30 11:49 AM ページ 14
1. Fasten the string cutoff blade to the debris shield
with two M5 x 12 screws and hex nuts as shown.
M5 x 30
Screw (2)
Gearcase
Plate
Hex Nut
String Cutoff Blade
2. Attach the debris shield to the shaft with the two
M5 x 30 screws and plate as shown.
[Handlebar Handle Models]
Installing Debris Shield
WARNING
POTENTIAL HAZARD
• Foreign objects can be thrown by the
Trimmer/Brushcutter.
WHAT CAN HAPPEN
• Contact with thrown objects can cause
personal injur y.
HOW TO AVOID THE HAZARD
• Never operate the Trimmer/Brushcutter
without the debris shield in place.
232025-10.indd 13
Shaft
Debris Shield
M5 x 12
Screw (2)
M6 x 30 Screw (2)
Gearcase
Debris Shield
Fig.1
— US-13 —
Debris Shield
Attach the debris shield to the gearcase with the two
M6 x 30 screws as shown on Fig. 1.
Extension Shield
(Install the string cutoff blade and shield extension to
the debris shield.)
1. Insert the square nut into shield extension as
shown on Fig. 2.
Square nut
2. Attach the String Cutoff Blade to shield extension
using M5 x 20 Screw, locking with square nut (on
Fig.2) as shown on Fig. 3 .
String Cut off Blade
M5 x 20 Screw
Fig.3
3. Enter the guide in the slot of debris shield on Fig.
4. Make sure place the three hooks into the posi-
tion on the shield as shown on Fig.5.
Debris Shield
Guide
Shield extension Hook
Shield extension
Fig.2
Fig.4
Hook
Fig.5
13/12/25 14:51