Assembly; Loop Handle Installation; Handlebar Installation; [Loop Handle Models] Installing Debris Shield - Maruyama B23L Manuel Du Propriétaire/De L'utilisateur

Assembly

Loop Handle Installation

The loop handle kit contains a package of four screws
nuts and the bottom clamp for the loop handle.
Screw (4)
Nut (4)
1. Place the loop handle and the bottom clamp
approximately 9 inches (22.8 cm) from the end of
the stop switch/throttle trigger assembly for an ini-
tial handle position.
2. Install the four screws and nuts. Leave the screws
finger-tight.
3. Reposition the loop handle up or down the drive
shaft to the most comfortable position, but no
closer than 9 inches (22.8 cm) from the end of the
stop switch.
4. Tighten the screws and nuts.

Handlebar Installation

IMPORTANT: Be careful not to damage the
throttle cable and stop switch wires when you
remove the handlebars from the shipping car-
ton.
232025-10.indd 12
Loop Handle
Handlebar
1.
2.
3.
Bottom Clamp
[Loop Handle Models]
Installing Debris Shield
POTENTIAL HAZARD
• Foreign objects can be thrown by the
WHAT CAN HAPPEN
• Contact with thrown objects can cause
HOW TO AVOID THE HAZARD
• Never operate the Trimmer without the
POTENTIAL HAZARD
• The cutoff blade is sharp.
WHAT CAN HAPPEN
• Contact with cutof f blade could cause
HOW TO AVOID THE HAZARD
• Keep hands, feet and clothing away from
— US-12 —
Throttle Trigger/Stop Switch
Stop Switch Wires/Throttle
Cable
Screw (4)
Clamp
Bracket
Loosen the four screws on the top of the clamp bracket.
Insert the left and right handlebars into the clamp
bracket. Note that the handlebar with the throttle
trigger and stop switch goes on the right-hand side
of the Brushcutter.
Adjust the handlebar to the desired position, then
tighten the four screws.
WARNING
Trimmer.
personal injur y.
debris shield in place.
CAUTION
serious cuts or personal injur y.
cutoff blade.
13/12/25 14:51