Click Volume, Tuning; Click Note Number; Click Mode; Click Out Select - Yamaha DTXPRESS III Mode D'emploi

If this parameter is set to "0", "NoAssign" will appear on the
display and sound will not be produced.
* Since sustained sounds cannot be used as a click voice, they
are not displayed.
* Refer to the [Drum Voice List] (P. 40).

4-3. Click Volume, Tuning

This sets volume and pitch for each of the 3 Click Voices.
UT CLK Click= hi
Vol=127 Tu=+0.0
w
q Click (Click Voice)
Selects the Click Voice. (The same Click Voice selected in func-
tion 4-2.)
w Vol (Click Volume)
[Range] 0-127
Adjusts the volume of the Click Voice selected in step q Click.
e Tu (Click Tuning)
[Range] –24 to 0 to +24.
Adjusts the pitch in 10-cent increments of the Click Voice selected
in step q Click.

4-4. Click Note Number

Sets the MIDI Note Number for each of the 3 Click Voices.
UT CLK Click= hi
Note#= 22 (A#-1)
q Click (Click Voice)
Selects the Click Voice. (The same Click Voice selected in func-
tion 4-2.)
w Note # (MIDI Note Number)
[Range] off, 1-127 (—, C#-2 to G8)
Sets the MIDI note number. The note number and note name will
be displayed.
If this is set to "off", the DTXPRESS III will produce sound
however; key on messages will not be transmitted.
* Refer to the preset drum kit's [Drum Voice List] (P. 40) for the
voice assignment of each MIDI note number.
q
e
q
w

4-5. Click Mode

This sets whether or not the click voice will automatically sound
during song playback.
UT CLK SETUP
ClickMode=manual
q ClickMode (Click Mode)
manual: The [CLICK] button will control on/off operation of the
click sound.
sync:
The click will sound during song playback, but will not
sound when the song is stopped. The [CLICK] button
can also be used to control on/off operation of the click
sound.

4-6. Click Out Select

Sets the output (left, right, or both) from which the click sound
will be delivered.
* Output from the PHONES jack on the front panel is the same as
output from the OUTPUT jacks on the rear panel, no matter
what the Click Out Setting may be.
UT CLK SETUP
OutSel=mix
q OutSel (Out Select)
mix:
Normal setting. The click sound is delivered from both
L and R output jacks.
clickL: The click sound is delivered from the L output jack
only. All drum sounds, sequencer sounds, etc. are pro-
duced in mono and delivered from the R output jack.
clickR: The click sound is delivered from the R output jack
only. All drum sounds, sequencer sounds, etc., are pro-
duced in mono and delivered from the L output jack.
Utility Mode
q
q
35