Trigger Setup Copy; Common Parameters; Common Parameters; Hi-Hat Offset - Yamaha DTXPRESS III Mode D'emploi

Trigger Setup Edit Mode

1-6. Trigger Setup Copy

This function copies all data settings in [1-1. Pad Type] to [1-5.
Specific Rejection] from input jack q to another input jack w.
TRIG IN= 1
Copy to Input= 1
When the Trigger Setup Copy operation is carried
out, the trigger setup data will be replaced with the
settings of the copy source.
q TRIG IN (Trigger Input Number)
Sets the trigger input jack number (1-10) of the pad copy source.
w Copy to Input (Trigger Input Number Copy Destination)
Sets the trigger input jack number (1-10) of the copy destination.
Procedure
1. In the display shown above, assign the copy source and
copy destination, press the [SAVE/ENT] button. The fol-
lowing display will appear asking for confirmation before
the copy operation is carried out.
Input Copy to 1
Are you sure ?
2. Press the [SAVE/ENT] or [VALUE+] button, the copy
operation will be carried out.
* Press the [VALUE-] button to cancel the copy operation.
When the copy operation is complete, "Complete!" will appear.
14
Contains common settings for all pad inputs (1-10).
This group is divided into the following 4 pages.
q
w
This sets the value of the data sent by a foot controller connected
to the HI HAT CONTROL jack on the rear panel. Set a + (plus) or
– (minus) level.
q HH OFFS (Hi-Hat Offset)
When a low data value is received from the foot controller, the
voice will sound sooner. So, slightly pressing the foot controller
will result in the voice sounding. In the case of the hi-hat control-
ler, delicate adjustment of the controller's "closed" point is pos-
sible.
w T (Foot Splash Detect Time)
Sets the detect time for the foot splash. Large values make foot
splashes easier to produce.
* Values too large will result in splashes being produced under
This sets the pad function that allows the currently selected drum
kit number to be increased or decreased by 1 by hitting the speci-
fied pad.
q IncIn (Pad for Increment)
Assigns the trigger input jack number that is set for the increment
(+1) function. "--" will appear when this function is not assigned
to the pad.
w DecIn (Pad for Decrement)
Assigns the trigger input jack number that is set for the decrement
(-1) function. "--" will appear when this function is not assigned
to the pad.

2. COMMON Parameters

2-1. Hi-Hat Offset .................................................... 14

2-2. Increment/Decrement ...................................... 14

2-3. Input Exchange ............................................... 15
2-4. Trigger Setup Name ........................................ 15

2-1. Hi-Hat Offset

TRIG Common
HH OffS= 0T= 32
q
normal hi-hat use.

2-2. Increment/Decrement

TRIG Common
IncIn= 4DecIn= 5
q
[Range] —, 1-10
[Range] —, 1-10
w
w