Facom E.516ST-30 Traduction De La Notice D'instructions Originale page 25

4. BLE status light 7 flashes to confirm wrench is in
pairing mode.
5. Open the App and follow pairing instructions on screen.
6. Once paired the BLE status light
7. Use the app to control the wrench.
nOtE: Observe the status lights during operation to
monitor the wrench.
Monitoring Status Lights During Operation
Torque status
stage tightening
Ready OFF
50-74% Orange – slow flash Vibrate - Soft
75-99% Orange – fash flash
Target GREEN
Over torque RED
Wrench Status Light
Blinking orange – startup/calibration
Orange – Battery / Memory / Calibration - check
Red – Battery / Memory / Calibration - attention
BLE Light
Flashing – ready to pair.
Constant – paired
Modes and Setting (Fig. A)
The wrench works in Manual mode (offline) when not
connected to the APP.
nOtE: Certain functions are only available when online, or
paired with a compatible device.
Offline Mode
When the wrench is not connected to the APP, this is referred to
as offline mode.
1. The last injected sequence can be repeated, if no sequence has
been injected the wrench is in tracking mode.
2. For details, refer to the in app menu.
Online Mode
In Online mode, the wrench is paired to a device. The APP is
open and connected.
1. This mode accesses the advanced functionality of the wrench.
2. Follow instructions on the app to set and control the wrench.
7 will be solid.
Haptic
OFF
Vibrate - Hard
Click
Function availability
Function Manual (Offline)
Set NO
(can perform the last
sequence set online)
Angle YES
Haptic YES
Target YES
Record YES (up to 500 cycles)
Find Me NO
Tightening

WARNING: Torque continues to climb during the
application of angle. It is possible to exceed the maximum
rated torque capacity of the wrench during angle. Ensure
the wrench has sufficient capacity.

WARNING: Failure to follow the warnings and
instructions listed below may result in electric shock, fire
and/or serious injury.

WARNING: Do not to position the wrench so that it is
difficult to operate the ratchet accessrory.

SHOCK HAZARD. To protect against risk of electrical
shock, do not expose wrench to water or other liquids.
1. Set the desired target torque either using off line or on
line mode.
2. Apply torque in the specified direction of rotation.
3. Refer to the Status table for details on the
feedback provided.
nOtE : For single pass torque and angle sequences, the target is
only achieved after the completion of the angle phase. Once the
target torque is achieved the wrench automatically switches to
angle. Angle count only increments when torque is applied. The
wrench will click to indicate angle phase is complete.
Applying Torque

WARNING : Familiarise yourself with operation and
feedback before use.
1. Ensure the socket is firmly and securely connected to the
fastening and wrench.
2. Hold the grip with one hand. Do not use accessories or
an extension.
3. Using smooth effort, pull the wrench at 90 degrees to the handle
4. Pay attention to the target torque and status lights.
nOtE : Haptic vibrate will warn when approaching target. Stage 1
is soft. Stage 2 is insistent and indicates target is close.
5. The wrench will click at 100% of the target value.
6. Stop tightening.
MAINTENANCE
Your FACOM power tool has been designed to operate over
a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
EngLIsH
app (Online)
Device
YES
YES
YES
YES
YES
23