Facom E.516ST-30 Traduction De La Notice D'instructions Originale page 22

EngLIsH

CAUTION:
• Hard impacts or dropping the wrench may impair accuracy of
the wrench. If the wrench is dropped or receives a sharp impact
have the wrench accuracy checked.
• To ensure correct operation and accuracy this product must be
calibrated periodically in line with standards.
Residual Risks
In spite of the application of the relevant safety regulations
and the implementation of safety devices, certain residual risks
cannot be avoided. These are:
• Impairment of hearing.
• Risk of personal injury due to flying particles.
• Risk of burns due to accessories becoming hot
during operation.
• Risk of personal injury due to prolonged use.
SAVE THESE INSTRUCTIONS
Important Safety Instructions for
All Battery Chargers
• Before using charger, read all instructions and cautionary
markings on charger, and product using battery.

WARNING: Shock hazard. Do not allow any liquid to get
inside charger. Electric shock may result.

WARNING: We recommend the use of a residual current
device with a residual current rating of 30mA or less.

CAUTION: Burn hazard. To reduce the risk of injury,
charge only FACOM rechargeable batteries. Other types of
batteries may burst causing personal injury and damage.

CAUTION: Children should be supervised to ensure that
they do not play with the appliance.
NOTICE: Under certain conditions, with the charger
plugged into the power supply, the exposed charging
contacts inside the charger can be shorted by foreign
material. Foreign materials of a conductive nature such as,
but not limited to, steel wool, aluminum foil or any buildup
of metallic particles should be kept away from charger
cavities. Always unplug the charger from the power supply
when it is not being used to charge the battery. Unplug
charger before attempting to clean.
DO NOT attempt to charge the battery with any chargers
•
other than the ones in this manual. The charger and
battery are specifically designed to work together.
These chargers are not intended for any uses other than
•
charging FACOM rechargeable batteries. Any other uses
may result in risk of fire, electric shock or electrocution.
Do not expose charger to rain or snow.
•
Pull by plug rather than cord when disconnecting
•
charger. This will reduce risk of damage to electric plug
and cord.
Make sure that cord is located so that it will not be
•
stepped on, tripped over, or otherwise subjected to
damage or stress.
20
Do not use an extension cord unless it is absolutely
•
necessary. Use of improper extension cord could result in risk
of fire,electric shock, or electrocution.
Do not place any object on top of charger or place
•
the charger on a soft surface that might block the
ventilation slots and result in excessive internal heat.
Place the charger in a position away from any heat source. The
charger is ventilated through slots in the top and the bottom
of the housing.
Do not operate charger with damaged cord or plug—
•
have them replaced immediately.
Do not operate charger if it has received a sharp blow,
•
been dropped, or otherwise damaged in any way. Take it
to an authorised service centre.
• Do not disassemble charger; take it to an authorised
service centre when service or repair is required. Incorrect
reassembly may result in a risk of electric shock, electrocution
or fire.
• In case of damaged power supply cord the supply cord must be
replaced immediately by the manufacturer, its service agent or
similar qualified person to prevent any hazard.
Disconnect the charger from the outlet before
•
attempting any cleaning. This will reduce the risk of
electric shock.
NEVER attempt to connect two chargers together.
•
• The charger is designed to operate on standard 230V
household electrical power. Do not attempt to use it on
any other voltage.
Charger
FACOM chargers require no adjustment and are designed to be
as easy as possible to operate.
Your FACOM charger is double insulated in accordance
with EN60335; therefore no earth wire is required.
If the supply cord is damaged, it must be replaced only by
FACOM or an authorised service organisation.
Using an Extension Cable
An extension cord should not be used unless absolutely
necessary. Use an approved extension cable suitable for the
power input of your charger (see Technical Data). The minimum
conductor size is 1 mm ; the maximum length is 30 m.
2
When using a cable reel, always unwind the cable completely.
Charging the Battery (Fig. B, C, D)
1. Connect the USB cable
charger 11 as shown in Fig. B.
2. Plug the charger into an appropriate outlet.
3. Place the wrench in the dock, making sure the wrench is
fully seated in the charger.
4. Fully charge the wrench for 4 hours.
- Fig. C shows the screen when battery is charging: LEDs
will be off and the OLED display will blink the charge level.
Fig. D shows the screen when battery is fully charged:
-
LEDs will be off and the OLED display will display a white
12 to charging dock 13 and