Fisher & Paykel DCS Evolution BE Serie Guide D'installation page 11

Locating Built-in Clearances
IMPORTANT!
Gas fittings, regulator, and installer supplied shut-off valves must be easily accessible.
FLAME LIFT
Wind hitting the grill while in use, (especially wind blowing into or across the hood gap) can cause
poor performance and in some cases can cause the control panel to get dangerously hot.
WIND
PRIMARY INTAKE
AIR FLOW
If wind is an issue, a windscreen should be added. The windscreen should be higher than the top of
the opening in the back of the grill, with a minimum clearance of 3" (76mm) for non-combustibles,
or 18" (457mm) for combustibles, from the back of the grill
INSTALLATION
EXHAUST
FIG. 01a
EXHAUST VENT FLOW
WIND
FIG. 01c
WIND
DIRECTION
PREFERRED
AIR FLOW
3" (76 mm) min. for
non-combustibles
18" (457 mm) min.
for combustibles
GRILL EXHAUST
EXHAUST
FIG. 01b
WIND
15" (381 mm) min.
EN
9