Beta 1946C4 8 Notice D'utilisation Et Instructions page 8

OPERATION MANUAL AND INSTRUCTIONS ISTRUZIONI PER L'USO
OPERATION MANUAL AND INSTRUCTIONS FOR AIR RIVETER MANUFACTURED BY:
BETA UTENSILI S.P.A.
Via A. Volta 18,
20845, Sovico (MB)
ITALY
Original documentation drawn up in ITALIAN.
CAUTION
Store the safety instructions with care and hand them over to the users.
PURPOSE OF USE
- The air riveter can be used for the following purposes:
• Installing blind rivets
• Applying copper-aluminium-steel-stainless steel rivets, 2.4 – 3.2 – 4 – 4.8 mm
• The air riveter can also be used in open places exposed to water and air
- The pneumatic tool must not be used for the following operations:
• The pneumatic tool must not be used in environments containing potentially explosive atmospheres.
• The trigger must not be locked with adhesive tape or clamps.
• The pneumatic tool must not be used for any applications other than stated ones.
WORK AREA SAFETY
- Beware of both surfaces that may become slippery due to the use of the machine and the danger of tripping over the air hose.
- While using the pneumatic tool for jobs performed high from the ground, take all necessary precautions, to eliminate or minimize
risk to other workers, following the accidental falling of any tools (for example, isolation of the work area and proper signs).
Do not operate the pneumatic tool in environments containing potentially explosive atmospheres, because sparks may be
generated, which can ignite the dust, fumes or gases.
Avoid contact with live equipment: the pneumatic tool is not insulated, and contact with live parts can cause electric shocks.
Do not use the air riveter without the nail container. The air riveter is fitted with an automatic suction system. During riveting
operations, nail ejection may cause damage to anyone working or standing near the work area.
Keep children and bystanders away from your workplace while operating the pneumatic tool. Distractions from other
people can cause you to lose control over the pneumatic tool.
PNEUMATIC TOOL SAFETY
- Do not point the air flow to yourself or other people. Compressed air can cause serious injury.
- Check the connections and the air supply lines. All units, couplers and hoses should conform to the product specifications in
terms of pressure and air volume. Too low pressure impairs the function of the pneumatic tool; too high pressure can cause
damage and/or injury.
- Do not bend or tighten any hoses; avoid using solvents and sharp edges. Keep the hoses away from heat, oil and rotating parts.
Immediately replace any damaged hose. A defective feed pipe may cause uncontrolled movements of the compressed air pipe.
Raised dust or chips may cause eye injury. Make sure that the hose clamps are always secured firmly.
PERSONNEL SAFETY
- Stay alert; watch what you are doing. Do not use the pneumatic tool while tired or under the influence of drugs, alcohol,
or medication.
- Always use the following personal protective equipment:
• Eye protection
• Safety shoes
• Hearing protection
• Protective gloves against physical agents
8
IMPORTANT! READ THIS MANUAL THOROUGHLY BEFORE USING
THE PNEUMATIC TOOL. FAILURE TO COMPLY WITH THE SAFETY
STANDARDS AND OPERATING INSTRUCTIONS MAY RESULT IN
SERIOUS INJURY.
EN I