Out Of Balance Recovery Routine; Auto Water Fill Level - Fisher & Paykel WA42T26GW1 Guide D'installation Et D'utilisation

Changing pre-set options
US
26
CA

Out of balance recovery routine

When your Ecosmart™ is spinning it can sense if the wash load is out of balance and will stop
and re-try spinning up to 3 times. If the machine still senses an unbalanced load there are two
options the machine offers.
Automatic recovery option:
Your Ecosmart™ will try to automatically
correct the out of balance load. It will fill with
water and agitate to redistribute the load
before trying to spin up again.
Machine stops option:
Your Ecosmart™ will stop, giving a short burst of beeps every five seconds and the RINSE or SPIN
light will flash. You must redistribute the load more evenly yourself (use this option if you wish to
conserve water.)
Enter the Option Adjustment Mode.
1
Use the REGULAR button to select the Out of Balance Recovery Option you prefer.
2
Press POWER to store your selection.
3

Auto water fill level

If you are not satisfied with the level that your
Ecosmart™ fills to on AUTO water level, you can
alter the fill level that AUTO will select. If you feel
there is too much water, you can decrease the fill
level that will be selected.
Enter the Option Adjustment Mode.
1
Use the CYCLE buttons to decrease the amount of
2
water selected.
Press POWER to store your selection.
3
Note: HEAVY DUTY (the default setting) provides the ideal water fill level. If you wish to change
it, we recommend changing one setting at a time until you reach the preferred level.
Out of balance recovery options
Regular
Light on = automatic recovery
Light off = machine stops
Less Water
Automatic Water Level Adjustment
Fig.37 Adjusting the water level
More Water