Water Supply - Fisher & Paykel AquaSmart Guide D'utilisation

Water supply

This washer must be plumbed into both a hot and cold water supply or it will not work correctly.
■ ■
Please ensure that both hot and cold water are connected to the washer.
If you have an uncontrolled water-heating source (eg a wet back or solar heating) you should
■ ■
have a tempering device fitted. This will ensure the hot water temperature remains within
safe limits. For the most suitable type of tempering device we recommend you contact a local
plumber or plumbing supply merchant.
Inlet water static pressure: Min. 5psi (34kPa) to Max. 150psi (1MPa) is required.
■ ■
Minimum flow rate from the faucet supplying the clothes washer should be greater than
■ ■
1 ½ gallons/min (6 liters/min) (assumes ½" (12.7 mm) diameter pipes).
Note: your washer does not have an internal water heater to heat water.
Draining
Regularly check that your standpipe or tub / sink is free from lint or other obstructions, which
■ ■
may affect how your washer works or may cause flooding.
In multi-storey apartments or any upper floor, the washer should be installed on floor equipped
■ ■
with a drain.
Draining must comply with local by-laws.
■ ■
Accessories and spare parts
Available from your Fisher & Paykel Dealer or Authorized Service Center.
Drain Hose Extension
Power Cord
Installation instructions
Part No. 425627p
If the Power Cord of your clothes washer is damaged it must be
replaced by a Fisher & Paykel Authorized Service Agent, as it is not a
standard power cord.
US
7
CA