Fisher & Paykel AquaSmart Guide D'utilisation page 41

Out of balance (OOB) recovery routine
When your washer is spinning it can sense if the wash load is out of balance. If an out of balance
load is detected, the washer will stop and retry spinning one more time. If it still senses an
unbalanced load there are two options the washer can take.
Automatic recovery OFF (default setting)
Your washer will stop, beep, and show "out-oF-bAL" in three phases on the display screen. You
must redistribute the load more evenly yourself and touch START / PAUSE to resume the cycle.
Use this option if you wish to conserve water.
Automatic recovery ON
Your washer will try to automatically correct the out of balance load. The machine will fill with
water and agitate to redistribute the load before trying to spin up again.
The washer will compensate for any out of balance by reducing the spin speed. As a result, your
clothes may be wetter than you expect at the end of the cycle.
To change the out of balance recovery routine:
Enter Option Adjustment mode (refer to page 36).
1
Select the DELICATE cycle.
2
Touch the MORE
3
automatic out of balance recovery on or off.
Fig.26 Changing the out of balance recovery routine
End of cycle (EOC) beeps
The beeps signalling the end of the cycle can be increased or decreased. The default setting is
5 beeps.
To modify the number of beeps sounding at the end of the cycle:
Enter Option Adjustment mode (refer to page 36).
1
Select the SHEETS cycle.
2
Touch the MORE
3
to increase the number of beeps, or for no beeps to sound at the end of the cycle.
Fig.27 Modifying the number of beeps to signal the end of the cycle
button (or HIGH EFFICIENCY button, depending on your model) to turn
Wash Temp
OOB Recovery
EOC Beeps
Factory Reset
or LESS button (or HIGH EFFICIENCY button, depending on your model)
Wash Temp
OOB Recovery
EOC Beeps
Factory Reset
Changing pre-set options
US
39
CA