Appliance Self-Test; Starting The Appliance Self-Test; Ending The Appliance Self-Test; Service - Bosch B22CS Serie Guide D'utilisation Et Entretien

Fault
Ice maker is not making
enough ice or the ice is
deformed.
Condensation forms on the
discharge unit of the
dispenser.
Appliance self-
test
Your appliance features an
automatic self-test program which
shows you sources of faults which
may be repaired by customer
service only.
Starting the appliance
self-test
Switch off the appliance and
wait 5 minutes.
Switch on the appliance again.
Simultaneously press the "+"
and "– " buttons for 5 seconds.
The self-test starts.
If "E.." is indicated on the display
panel, an error has occurred.
If a fault is indicated, inform
customer service.
Ending the appliance
self-test
Press the "+" and "– " buttons
again for 5 seconds.
Possible cause:
Low water pressure.
The environment is to humide.

Service

If you need service, first see the
section "Eliminating minor faults
yourself" of this book.
After checking this section,
additional help can be found by
calling the Bosch Customer
Interaction Center,
1–800–944–2904 (toll-free),
from anywhere in the U.S.A.
In Canada, contact your designated
Bosch Canada service company or
call 1–800–944–2904.
Write down the following information
about your refrigerator to better help
you obtain assistance or service if
you ever need it.
Dealer name:
Address:
Phone number:
Purchase date:
Model number (E):
Serial number (FD):
Remedial action
Connect appliance to stipulated water
pressure only (see section "Installation
/ Water connection").
Switch on the condensation heating.
To switch on the condensation
heating: press the switch to "1".
To switch off the condensation
heating: press the switch to "0".
You will need to know your complete
model number (E) and serial
number (FD).
You can find this information on the
rating plate located on the inside wall
of the refrigerator compartment.
+
25