Yamaha NP-S303 Mode D'emploi page 51

Problem
The iPhone does not detect the unit
when using AirPlay.
The unit is not detected when using a
dedicated application on a mobile
device.
The firmware on this unit failed to update
via the network.
The unit is unable to connect to the
wireless LAN router (access point).
Cause
You may be using a router that supports multiple SSIDs.
The unit and the mobile device are not on the same network.
You may be using a router that supports multiple SSIDs.
The network connection may not be good.
MAC address filtering may have been enabled on the wireless LAN
router (access point).
Solution
The router's network separator function may be blocking access to the
unit. If you are connecting an iPhone to the unit, use an SSID that allows
access to the unit. (Try to connect to the Primary SSID.)
Check the network connection and the router settings to make sure that
they are connected to the same network.
The router's network separator function may be blocking access to the
unit. If you are connecting an iPhone to the unit, use an SSID that allows
access to the unit. (Try to connect to the Primary SSID.)
Try updating again after a while. Alternatively, update the firmware using
a USB memory device.
The unit is unable to connect to the router if MAC address filtering is
enabled. Change the setting on the wireless LAN router (access point),
and try to connect the unit again.
Page
—
—
—
46
—
51
En