Yamaha Motor YDRE Manuel D'exploitation page 40

Grounding
The battery charger must be
grounded to reduce the risk of electric
shock. The charger is equipped with
a 3-prong AC cord set. The AC cord
set must be connected to an
appropriate receptacle that is properly
installed and grounded in accordance
with the National Electrical Code and
all local codes and ordinances.
Improper connection of the
equipment-grounding conductor
can result in a risk of an electric
shock.
The conductor with insulation that
has an outer surface that is green,
with or without yellow stripe(s), is the
equipment-grounding conductor. If
repair or replacement of the charger's
AC cord set is necessary, do not
connect the equipment-grounding
connector to a live terminal.
JC1
MAINTENANCE
Charging
To reduce the risk of an electric
shock, connect only to a properly
grounded, single-phase (3-wire)
outlet. Also, refer to grounding
instructions.
Risk of electric shock! Do not
touch any uninsulated parts of the
charger output plug, DC charger
receptacle or battery terminals.
Surfaces may be hot. To avoid risk
of burns, do not touch.
NOTICE
Charge only 48-volt battery
systems manufactured by Trojan
Battery Company. Damage to the
charger and batteries may result if
this charger is used on the wrong
battery type.
1
2
3
4
5
6
7
8
9
10
11
7-12