Fisher & Paykel AeroCare Instructions D'installation Et Guide D'utilisation page 49

Servicing
Important!
Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper
and dangerous operation after servicing/installation.
For service and other information, refer to the "How to get service" section in the back of this
book (refer to page 86).
Drum light replacement
Before replacing the light bulb, be sure to unplug the
dryer power cord or disconnect the dryer at the household
distribution panel by removing the fuse or switching off
the circuit breaker. Reach inside, above the dryer opening
inside the drum. Remove the bulb and replace with the
same size bulb.
Installation instructions
Fig.43 Drum light
47 CA
(EN)