Fisher & Paykel AeroCare Instructions D'installation Et Guide D'utilisation page 45

Reattach the hinges on the opposite side to the door handle, using the same four screws on the
8
hinge retained from removing the hinges in Step 5.
Important!
Check the position of the hinge as shown in Figure 38.
To change the direction of the door strikes, unscrew both the cover plate and the strike plate
9
(the strike plate being the plate with the metal part protruding). Reinstall one plate in place of
the other.
Install the door on the opposite side of the opening by moving the door in and down until the
10
top hinge and bottom hinge are resting on the two screws inserted in Step 3. With the two
screws retained in Step 4, secure each hinge at the bottom.
Tighten the two top screws of each hinge.
11
Fig.38 Fixing hinges to opposite side
Fig.39 Exchanging cover plate and strike plate location
Fig.40 Installing the door in the reverse position
Installation instructions
43 CA
(EN)