Fisher & Paykel AeroCare Instructions D'installation Et Guide D'utilisation page 37

Dryer exhaust to right, left or bottom of cabinet
Before performing this exhaust installation, be sure to disconnect the dryer from its
electrical supply. Protect your hands and arms from sharp edges when working inside
the cabinet. Be sure to wear gloves.
Important!
Dryer exhaust to right of cabinet (electric models only).
Dryer exhaust to left of cabinet (gas and electric models).
Detach and remove the bottom, right or left side knockout (the opening for alternate ducting),
as preferred for the direction of ducting. Tape around the knockout and exhaust opening to
provide protection from sharp edges during installation. Remove the screw inside the dryer
exhaust duct and slide the duct out of the dryer. Keep the screw. Cut the duct as shown in
Figure 24. Retain portion A of the duct.
Right (electric
models only)
Remove screw
and save
Bottom (gas
and electric
models)
Tab location
Through the rear opening, find the tab located in the middle of the dryer base. Using a flat blade
screwdriver, lift the tab to approximately 45°.
Bend tab
up 45°
Fig.25 Lifting the tab
Installation instructions
WARNING!
Left (gas and
electric models)
Remove desired
knockout (one only)
Fixing hole
9" (230 mm)
Fig.24 Removing and
shortening the duct
35 CA
(EN)