NEC MultiSync 20WMGX2 Manuel De L'utilisateur page 18

Operating Instructions
The OSM (On-Screen Manager) control buttons, located on the front of the monitor, function
®
as follows:
To access OSM menu, press the MENU/EXIT button on the front of the monitor or press the "MENU" button on the
remote control.
Front Buttons Remote Control
MENU/ MENU
EXIT
Left/Right Left/Right Arrow Moves the highlighted area left/right to select
Down/Up Down/Up Arrow Moves the highlighted area down/up to select
SELECT Enter
RESET/ DV Mode
DV MODE
Brightness/Contrast Controls
BRIGHTNESS Adjusts the overall image and background screen brightness.
CONTRAST Adjusts the image brightness in relation to the background.
AUTO CONTRAST (PC2 input only) Adjusts the image displayed for non-standard video inputs.
BLACK LEVEL (PC2 input only) Adjusts the black level.
ADVANCED DV MODE Activates the Advanced Dynamic Video Mode.
DV MODE Selects the best setting for Video, Photos, Text, etc.
TINT (Video 1, Video 2, TV input only) Adjusts the tint.
COLOR GAIN (Video 1, Video 2, TV input only) Adjusts the intensity of the RED, BLUE or GREEN colors.
SHARPNESS Adjust the image to get distinct or as soft a picture as is preferred.
Image Controls
AUTO ADJUST (PC2 input only) Automatically adjusts the Image Position setting,
H. Size settings and Fine settings.
* Depending on the type of signal displayed, displays may not be optimized through Auto Adjust.
Manually adjust to optimize them.
* When operating the TV the first time, channels must first be set up in order to watch TV programs.
Refer to page 20 to setup the TV system.
POSITION (All inputs except PC1) Increases or decreases the horizontal size.
H.SIZE (PC2 input only) Adjusts the horizontal and vertical position of the picture.
If the "Auto Adjust function" does not give you a satisfactory picture setting, further tuning can be
performed manually using the "H. Size" function (dot clock).
FINE (PC2 input only) If the "Auto Adjust" and the "H.Size" functions do not result in a satisfactory
picture, further tuning can be performed using the "Fine" function. Increasing or decreasing this setting
improves focus, clarity and image stability.
Note: Availability of OSM controls depends on the type of input signal displayed.
continued
When using OSM
Exits the OSM sub menu.
Exits to the OSM main menu.
control menus.
Moves the bar left/right to increase or
decrease the level of adjustment.
which controls are to be adjusted.
Enter the OSM sub menu.
Sets new adjustment.
Resets the highlighted control menu to the
factory setting.

When not using OSM
Enters the OSM menu.
Controls Volume.
TV mode: Changes channels.
PC1, PC2 mode: Enter HOT
KEY menu.
Change input source.
Selects the DV MODE.