NEC MultiSync 20WMGX2 Manuel De L'utilisateur page 11

Installation Instructions
3. Remove the Cable Cover. Push the cover up (towards the top of the monitor) in order to unhook the cover
from the stand. Tilt the LCD panel backwards 30° (Figure 5).
4. Remove the connector cover (Figure 6).
5. Connect all cables to the appropriate connectors through the square hole in the stand (Figure 7).
6. Place the connector cover back onto the monitor.
7. Place all cables into the hooks on the stand (Figure 8).
8. Place hands on each side of the monitor to tilt the LCD panel back 5° and place the cable cover back onto the
stand (Figure 9).
9. Connect the power cord to the power outlet.
NOTE: Refer to Recommended Use section of this manual for proper selection of power cord.
10. The Vacation Switch located on the back side of the monitor (Figure 10) must be turned on in order for the
monitor to operate. With the Vacation Switch in the ON position, power the monitor on using the front power
button and turn on the computer.
NOTE: The vacation switch is a true ON/OFF switch. If this switch is in the OFF position, the monitor cannot
be turned on using the front button. DO NOT switch on/off repeatedly.
11. No-Touch Auto Adjust (PC2 input only): For most signal timings (resolution settings), No-Touch Auto Adjust
automatically adjusts the monitor to optimal settings upon initial setup. For further adjustments, use the
following OSM controls:
®
• Auto Adjust Contrast
Refer to the Controls section of this User 's Manual for a full description of these OSM controls.
NOTE: For download information on the Windows
file for your monitor, refer to the References section of this User's Manual.
NOTE: If you have any problems, please refer to the Troubleshooting section of this User's Manual.
Figure 5
Figure 8
continued
• Auto Adjust
95/98/Me/2000/XP INF
®
Figure 6
Figure 9

Figure 7
Figure 10
ON Position
Vacation
OFF Position
Switch