Remote Installation (Optional) - Thermador Professional VCIB Serie Manuel D'installation

6. Connect the "pigtail" to the connector inside the
junction box.
SPEED 1 RD
SPEED 2 BU
SPEED 3 BN GROUND
NEUTRAL WH
WH / BC / BL (16 AWG)
BK / N / NE (16 AWG)
120V, 60HZ, 20A
POWER SUPPLY
Figure 14: Wiring the Hood with an Inline Blower
7. Close the junction box cover.
8. Run five (5) wires (#14 AWG) in 1'' (25.4 mm) conduit
from the inline blower to the second conduit connector.
9. Connect the inline blower to the pigtail wires as per
Figure 14. Connect the inline blower green (ground)
wire to the ground screw in the junction box.
Remote Control Installation
(optional)
NOTE: When using the Custom Insert with the optional
remote control, the unit loses the "AUTO" function and
the over-temperature heat sensor described in the Use
& Care Guide.
It is recommended that the Remote Control be wired to the
hood after the hood is installed.
1. Access wiring
a) Remove filters, spacers and grease trays.
b) Remove the junction box cover (refer to Figure 7
on page 10).
c) Remove three screws holding stainless steel panel
to the canopy.
Figure 15: Remove stainless steel panel
SP4
Brown Brown Brown
Green/Yellow Green/Yellow Green/Yellow
White White White
N
SP1 Red Red Red
Blue Blue
Blue
SP2
Orange Orange Orange
SP3
d) Remove core partition (Figure 16).
2. Connecting the harness to the relay board.
a) Unplug harness from the remote control to the
relay board (Figure 17).
b) Plug in harness included in the remote kit
(Figure 17).
c) Run harness through core partition hole
(Figure 18).
Figure 18: Wire Routing through Partition
Figure 16: Remove core partition
Figure 17: Relay Board Hookup
English 13