Junction Box Installation; Junction Box Wiring - Mettler Toledo InPro 7200 Serie Instructions D'utilisation

16
5

Junction Box Installation

5.1

Junction Box Wiring

1. Remove the junction box cover and loosen the cable connec-
2. Insert the sensor cable through the appropriate connector
3. Insert extension cable assembly through appropriate
Junction box
InPro 7200 Series
52 001 408
tors.
and connect the numbered terminals of the sensor cable to
the corresponding numbered terminals on the terminal strip.
Note: For maximum accuracy, sensor should not be locat-
ed more than 30 m (100 ft) from Transmitter Cond Ind
7100 e, CondI7100/2H, CondI7100/2(X)H or M 700.
connector and connect the numbered terminals of extension
cable assembly opposite the corresponding number.
Figure 6: Junction box "ZU 0074X"
Figure 7: Junction box "ZU 0307"
© 08/04 Mettler-Toledo GmbH, CH-8606 Greifensee
InPro 7200 Series
Printed in Switzerland