InPro 7200 Series
4.5
Immersion Installation
For open tanks or inlet channel the sensor can be installed in an
immersion housing InDip 550Ind.
4.6
In-Line Installation
For in-line applications within a metal or plastic pipe, the pipe
must have a minimum diameter of DN80 (3"), and the sensor
should be aligned as closely as possible with the centerline of
the pipe.
Larger pipe diameter should be used wherever possible.
Note: Whenever the minimum size pipe diameter is used, the
system should be calibrated with the sensor in place and with
a solution of known conductivity (within the range of the instru-
ment's calibration).
© 08/04 Mettler-Toledo GmbH, CH-8606 Greifensee
Printed in Switzerland
Figure 5: Immersion housing "InDip 550Ind"
15
InPro 7200 Series
52 001 408