Pioneer DVJ-X1 Mode D'emploi page 48

Advanced Operations (Operations Using Memory Cards)
HOT CUE
A
B
C
REC MODE
I To read a cue/loop point into a hot cue
1. Press the CUE/LOOP CALL button.
¶ The preview monitor screen will display the cue point navigation
menu.
CUE 1–001 0.11.05
A B C
ENTER CALL
While the call screen is displayed, point
information is also shown on the play-
er's display.
2. Use the cursor button to select the desired thumbnail im-
age, and press the HOT CUE REC MODE button so that
the HOT CUE A, B, and C button indicators light red. Then
press the button (A, B, or C) into which you wish to store
the hot cue point.
While reading data from the memory
card, the main unit's display will show
the "HOT*readin" message.
¶ Playback will begin when data reading is completed.
A B C
44
En <DRB1388>
CUE/LOOP
CALL
ENTER
CUE
¶ When a copy-protected disc is loaded, the recorded points on the
sub-screen cannot be stored in the memory card.
1–001 1–002 1–003
0.23 0.04
1–004 1–006 1–006
0.07 0.00
1–006 1–006 1–006
0.20 0.28
CUE 1–006 0.06.00
A B C
ENTER CALL
If no thumbnail image is displayed, cue
point or loop point memory point time
data will be displayed.
¶ Cue point navigation screen when CD is loaded.
TRK–01 TRK–01 TRK–01
0.35 0.39
CUE TRK–01 0.39.60
A B C ENTER CALL
Point information is also shown on the
main unit's display, allowing you to
select points even without a preview
monitor.
I To recall a memorized hot cue point
Hot cue points A, B, and C are recorded automatically on the memory
card. If hot cue points are recorded at the time a disc is inserted, the
HOT CUE buttons A, B, C, will flash green. To call up one of the recorded
hot cue points, press the corresponding button A, B, or C. The flashing
green indicator will light steadily (when calling, sound will not begin in-
stantly). If you have no need of calling one of the hot cue points, press
the HOT CUE REC MODE button. The indicators will change to red, and
the hot cue setting mode will be enabled. (To subsequently call up one
of the hot cue points previously recorded on the memory card, remove
the disc or memory card and reinsert it so that the A, B, and C buttons
flash once again. Then press the desired flashing button).
I WAVE display
When playing a track with which you have previously used the WAVE
display function, the recorded WAVE pattern will automatically be re-
called and displayed.
1–004
0.05 0.02
1–006
0.06 0.12
1–006
0.45 1.11
TRK–03
3.57 0.11