Pioneer MCS-838 Mode D'emploi page 74

74 Advanced settings
En
Setting
DRC (Dynamic Range
Control)
Speaker Setup
Test Tone
Color Space
Resolution
HDMI Audio Out
HDMI Deep Color
HDMI 1080P 24Hz
8
HDMI 3D
3D Notice
HDMI In Audio Through
Control
Options Explanation
Off Select this to output audio signals without using the DRC function.
On Select this to adjust the range between the loudest and softest sounds
(dynamic range) for playback at average volume. Use this when it is hard to
hear dialog or when watching movies at midnight.
Select to switch the DRC setting On/Off automatically according to the input
Auto
audio signal from the disc. This only affects Dolby TrueHD signals.
Adjust the Trim (output level) and Delay (distance from viewers) of the speakers.
Please see "Adjust speaker settings" for more details (page 77).
Output a test tone from the speakers.
RGB Select this to output the video signals as RGB signals. Choose this if the
colors seem too faint and the black seems too bright.
YCbCr Select this to output the video signals as YCbCr 4:4:4 signals.
Select this to output the video signals as YCbCr 4:2:2 signals.
YCbCr 422
Full RGB Select this to output the video signals as RGB signals. Choose this if the
colors seem too dense and all the dark colors are displayed in a uniform
black.
Select this to choose the resolution of the video signals output from the HDMI
Auto
OUT terminal automatically.
480I/576I Output the video signals from the HDMI OUT terminal with the selected
resolution.
480P/576P
The resolution can be changed by pressing RESOLUTION, but Auto cannot be
720P
selected.
1080I
1080P
Bitstream Select this to output HDMI audio signals directly.
Select this to output HDMI audio signals converted to PCM audio signals.
PCM
Reencode
two audio signals are mixed and converted to DTS audio for output.
Off Select this when you do not want to output the audio signal from the HDMI
output terminal.
30bits Select this when outputting the video signals with 30-bit color.
36bits Select this when outputting the video signals with 36-bit color.
Select this when outputting the video signals with normal 24-bit color.
Off
Select this when Resolution is set to Auto or 1080P and outputting 1080p/24
On
video signals to a TV compatible with 1080p/24.
Off Select this when Resolution is set to 1080P and outputting 1080p/60 video
signals to a TV compatible with 1080p/60.
Auto
Off 3D images are not played.
This sets whether or not to display the 3D notice when playing 3D images.
Yes
No
On Specifies the routing of the HDMI audio signal out of this system (amp) or
Off
Off: Playback using speakers connected to the unit.
On: Playback through TV connected to the unit via HDMI output
Select this to control the player with the remote control of the connected AV
On
device using an HDMI cable. Also refer to page 35.
Off Select this when you do not want to control the player with the remote control
of the connected AV device using an HDMI cable.
YCbCr 422.