Maintain And Storage; Troubleshooting - Texas Power Split 2000 VH Guide D'utilisation

Maintain and storage

Before performing maintenance, the log splitter must be placed in maintenance mode.
1.) Turn off engine.
2.) Move the control valve handle forward and backward to relieve hydraulic
pressure.
After performing maintenance, make sure all guards, shields, and safety features are put
back in place. Failure to follow this warning can result in serious injury.
Refer to the engine owner's manual for engine maintenance.
What
Hoses
Hydraulic Fittings Each Use
Nuts and Bolts
Beam
Moving Parts

Troubleshooting

Problem
Cylinder rod will not move
Slow cylinder rod speed when extending or
retracting
Wood will not split or splits extremely
slowly
Engine bogs down during splitting
Engine stalls under low load condition
When
Each Use
Each Use
Each Use
Each Use
Inspect for exposed wire mesh and leaks. Replace
all worn or damaged hoses before starting engine
Inspect for cracks and leaks. Replace all damaged
fittings before starting engine
Check for loose bolts
Apply grease to beam surface
Clear debris
SOLUTION: A,D,E,H,J
SOLUTION: A,B,C,H,I,K,L
SOLUTION: A,B,C,F,I,K
SOLUTION: G,L
SOLUTION: D,E,L,M
How