Advanced Menu - LD Systems DSP 44 K Manuel D'utilisation

MENU ITEM 7 - INPUT ROUTING
Route inputs 1 to 4 to channels A to D.
Briefly press the MENU dial to access the device settings selection menu and then turn the dial to select menu item 7. Input Route off.
Now press one of the buttons SELECT A to D and make the desired setting in the relevant channel by turning the dial (route inputs 1–4, 1
+ 2 , 3 + 4). Press the dial to activate. In order to select and edit one of the other channels A to D, turn the dial to move the arrow to the
desired channel, press the dial and make the settings as described above. In order to return to the main display, briefly press the EXIT /
LOCK button, several times if necessary.
MENU ITEM 8 - INPUT SIGNAL
Set the input signal (analogue, DANTE - LD DSP44K only.
Briefly press the MENU dial to access the device settings selection menu and then turn the dial to select menu item 8. Input Conf. off.
Press one of the buttons SELECT A to D to make the desired setting in the relevant input pair by turning the dial (input 1 + 2, input 3 + 4).
Press the dial to activate. In order to select and edit the other input pair, turn the dial to move the arrow to the desired pair, press the dial
and make the settings as described above. In order to return to the main display, briefly press the EXIT / LOCK button, several times if
necessary.
MENU ITEM 9 - OUTPUT CONFIGURATION
Set the output configuration (Single, 2-Way active, Bridge).
Briefly press the MENU dial to access the device settings selection menu and then turn the dial to select menu item 9. Outp. Conf. off.
Press one of the buttons SELECT A to D and set the desired output configuration for the relevant channel pair by turning the dial. Press the
dial. Turn the dial until Yes appears in the bottom line and then press again to confirm. In order to select and edit the other channel pair, turn
the dial to move the arrow to the desired pair, press the dial and make the settings as described above. When the output configuration is
changed, the data of the previously loaded preset is overwritten. In order to return to the main display, briefly press the EXIT / LOCK button,
several times if necessary.

ADVANCED MENU

Press and hold the MENU dial for about 3 seconds to get to the advanced menu. Select the desired menu item by turning the MENU dial
(note position of arrow) and confirm by pressing the dial. The menu item Amp Preset is for managing the amp presets, while the menu
item Amp Setup allows an individual amp name to be entered, as well as the IP address and a password if required. The temperature of
the individual amp channels can be viewed as a percentage under the menu item Amp Temperature, while Amp Info provides the serial
number, firmware version and operation time.
Amp Preset - Load Amp Preset
In order to load a saved amp preset from the internal memory, select the menu item Load Amp Preset by turning the MENU dial and
confirming by pressing the dial. Now select the amp preset to be loaded by turning the dial once again and confirm by pressing the dial. In
the subsequent dialogue, turn the dial to select "Yes" and confirm by pressing the dial. In order to return to the main display, briefly press
the EXIT / LOCK button twice.
9