Configuration - Festo SB 60 Notice Simplifiee

VISB/SF 60
2

Configuration

PLEASE NOTE:
When opening the terminal: connecting cables prevent the
cover from being fully lifted.
CAUTION:
The valve terminal components contain electronically sensitive
components. Touching the contact surfaces of connectors or
ignoring proper handling procedures for electrostatically sen-
sitive components may destroy the components.
Proceed as follows when configuring:
1. Turn off supply voltage.
2. Open node (take care not to lose screws or O-ring for the
PROG interface).
3. Set bus connection and grounding for DH-485.
4. Close node.
5. If one of the interfaces is unused:
Close it off with a protective cap (IP65).
12
9804a