Leister WELDPLAST S2 Instructions D'utilisation page 16

GB
Operating Instructions
Read the operating instructions carefully before starting
the device and keep them for future reference.
Leister WELDPLAST S2 / S2-PVC / S2-TPO
Hand Extruder
Application
Extrusion welding of the following materials:
WELDPLAST S2
WELDPLAST S2-PVC
WELDPLAST S2-TPO PP / PE-HD / PE-LD / TPO
Other materials on enquiry
The hand extruder corresponds to the DVS standard 2207–4.
DVS: Deutscher Verband für Schweisstechnik (German Association for Welding Technology)
Warning
Opening the device is extremely dangerous, since live parts and connections are exposed. Remove the
plug from the socket before opening the device. Electro-conductive material (e.g. PE-EL) may not be welded.
Danger of fire and explosion if the hand extruder is used incorrectly (e.g. overheating of material),
particularly near combustible materials and explosive gases.
Danger – can cause burns! Do not touch bare metal parts and emerging material while hot. Allow
the device to cool. Do not direct stream of hot air or emerging material towards people or animals.
Connect device to power socket with protective earth conductor. Any break in the protective earth
1
conductor inside or outside the device is dangerous!
Only use extension cables with a protective earth conductor!
Caution
The nominal voltage indicated on the device must correspond to the mains voltage. If power failure
120
occurs, the main switch and drive must be switched off (release locking device).
230
When using the device on building sites, a residual current circuit breaker is essential for the safety
FI
of persons there.
The device must not be left unattended when in use. Heat can reach combustible materials which are
out of sight.
The device may only be used by trained personnel or under their supervision. Children may not
use the device under any circumstances.
Keep away from wet and damp areas.
16
PP / PE-HD / PE-LD
PP / PE-HD / PE-LD / PVC-U
(Translation of the original operating instructions)