Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7.1 Detector for grade rods or
handheld applications
Level vial
LCD
screen
(front)
Detection
window
Rod clamp
Turn to attach
clamp to detector
Turn to tighten
or remove clamp
from rod
14
On-grade
alignment notch
Keypad
Choice of
sound level
Choice of
accuracy
On/Off
LCD screen
(rear)
Bubble vial
to plumb
rod
9V battery
compartment
(follow polarity
indications
inside)
• LCD Display
High
Near
grade high
On-grade
Near
Standard
grade low
(
Default
mode
Low
• Using the detector
1. Press the On/Off key to turn on the detector.
2. Press the middle key to select the accuracy (deadband).
3. Press the top key to select the sound level.
4. Turn the detection window towards the laser beam, and
move the detector up or down according to the information
given on the LCD display. There are 5 channels of information,
or grade indicators.
A down arrow indicates you must move the detector down to
reach the laser reference; an up arrow, move it up. When a
horizontal line appears on the display, the detector is at the
same level as the laser beam.
5. Press the On/Off key to turn the detector off. It will
automatically shut off after 10 minutes if not used (and give a
warning beep).
6. Keep the detection window clean, using a soft cloth and
glass cleaner.
* Troubleshooting
If you cannot pick up the beam with the detector, check how
you are lined up with the laser. One of the head protection
supports on the laser may be blocking the beam; move to the
left or right to receive the beam.
The metal head protection can be removed from the laser by
pivoting the two security locks. This will not affect the
performance or the water or dust resistance of the laser.
B
Low battery
ATTERY STATUS
Blinking: Normal volume
Solid: Loud
S
OUND
No horn: Mute
A
CCURACY
Fine
)
15
Publicité
Chapitres
Table des Matières
