Foot Rests - Quickie Krupton F Notice D'utilisation

6.3 Foot rests

Various footboards are available on the Xenon². These can be
flipped up to make it easier to transfer to/from the chair. They are
described individually.
Lower leg lengths
By undoing the clamp screw (Fig. 6.3.1), you can adjust the lower
leg length. Loosen the clamp screw, adjust the tube with the
footboard to the desired position.
Tighten clamp screws again (see the page on torque). Ensure that
the plastic push joint is located under the clamp screw in the
correct position.
WARNINGS!
• When transferring to and from the wheelchair, do not stand on
the footplates. If you stand on the footplates, there is a risk of the
wheelchair tipping forwards. When transferring to and from the
wheelchair, make sure that your feet are firmly on the ground.
Platform Footrests
The footplates can be flipped up to make it easier to transfer to and
from the chair.
The footplates can also be tilted to six different angles relative to a
level surface.
Tighten screw (1) firmly on the outer side.
By removing the clips (2) the footrest can be adjusted to three
different positions toward both the front and rear. Loosen the
adjustment screw (3) to change the horizontal position of the
footboard.
For this purpose, the footboard must be flipped up,
(Fig. 6.3.2 to Fig. 6.3.4).
When finished, make sure that all screws have been properly
tightened (see the page on torque).
A minimum interval of 25mm from the ground should always be
maintained.
Krypton F
Fig. 6.3.1
Fig. 6.3.2
Fig. 6.3.3
Fig. 6.3.4
18 Rev.1.0