Security Terms; Starting And Stopping - Benassi BL200 Livret D'utilisation Et D'entretien

S.p.A.
WARNING:
Please read very carefully this booklet before using your cultivator; Carefully using and servicing this machine, you will certainly
get satisfactory performances for a long time.. FAILURE TO COMPLY WITH THESE INSTRUCTIONS MAY RESULT INSIDIOUS OR
EVEN FATAL INJURY.
•
The use of the machine is forbidden to persons younger than 16 years.
•
The operator is responsible of any possible damage and he should always drive the machine carefully and safety.
•
Before carrying the machine always empty the fuel tank.
•
Never use the machine without heavy shoes and long trousers. Always inspect the area where you want to work taking off
stones, branches, cables and any other thing which can be dangerous.
•
Before start working, make sure that a radius of minimum 5 metres is completely free.
•
Fill up when the engine is off and not hot, always in an open space far from fires or any heating source and refrain from
smoking during this operation.
•
Clean any possible leakage of fuel.
•
Before starting the machine make sure that you can quickly stop the engine and that you are familiar with the control levers.
•
Never allow the engine to run in enclosed spaces where the highly toxic carbon monoxide could not evacuate.
•
Never start or use the machine not completely assembled or without the safety device.
•
Never fix or clean the tiller blades or any other tools when the engine is running.
•
Attention ! Don't use the machine on sloping grounds exceeding the limit shown in the use and maintenance booklet of the
engine.
•
We are not responsible for accidents due to the wrong use of the machine neglecting the above basic instructions.
Starting the engine of the machine always follow these instructions very carefully:
•
Check the oil in the engine : THE BRAND NEW MACHINE IS DELIVERED WITHOUT OIL IN THE ENGINE, THEREFORE YOU SHOULD
FILL IT UP TO THE LEVEL ON THE DIP STICK OF THE OIL CUP.
•
Please check the engine USE AND MAINTENANCE concerning the "operations before starting".
•
Start the engine only in open spaces.
1. Pull the choke lever on the engine (Fig.n°1 Ref."6").
2. Turn the accelerator lever to the "MAX" position (Fig.n°6 Ref."A").
3. The levers (Fig.n°7 Ref."A" and "B") should be released (position "a").
4. Pull the starting rope by the handle (Fig.n°1 Ref."12") smoothly first than strongly, when you feel some resistance don't leave
the handle but help the recoiling of the rope with your hand.
5. For the stopping engine turning the engine stop button (Fig. n°1 Ref. "17") in the "STOP" position. (HWASDAN)
6. For stopping the engine move the accelerator lever in the "STOP" position.
STARTING AND STOPPING THE MACHINE
SECURITY TERMS
BL200/BL 250
19