Technical Details; Instruction For Motorhoe Assembly - Benassi BL200 Livret D'utilisation Et D'entretien

S.p.A.
FOR THE ENGINE FEATURES SEE THE ENGINE INSTRUCTION BOOKLET DELIVERED WITH THE MACHINE.
• Acoustic pressure to the operator's ear: LpA = 81 dB (A)
• Vibration to handlebar with weighting ISO.5349 value: from 8,98 m/sec².
Test condition: 1,6 Mt in the middle of the handlebar
The engine fitted on this tiller have following features:
• Exhaust guard
• Recoil starter
• Dry air filter
• LUBRICATION 4 STROKES ENGINE: see instruction manual of the engine.
• Quantity of engine oil: see instruction manual of the engine.
• Fuel: unleaded petrol.
• Safety device for both forward and backward gear stopping the tiller.
• The transmission has got double belt transmission (front and reverse) for the engine and a greased chain for the tiller.
• The handlebar can be adjusted in 2 vertical positions (Fig.n°2).
• The tiller is 50 cm wide (Fig.n°9).
• The gear‐box is screwed (Fig.n°3 Ref."A").
• The ridger is adjustable in three different positions (Fig.n°3 Ref. "B").
All the identification references (code number, engine, weight, power) are printed on the number plate on the machine (Fig.n°4 Ref.
"A").
The machine is packed in a box with following dimensions :
◊
WIDTH: 70 cm
• Take the machine out of the carton box.
• Fit the rear spur in its place using the delivered pin.
• Fit the handlebar on the support through the two screws and the nut which are already fitted on the handlebar.
• Fit the front transfer wheel to its holder, already fitted on the frame, by using the screw, the bush and the nut (Fig.n°5 Ref."A").
• During the transport the handlebar can be left unassembled by removing both screws that fix it to the handlebar support
18
TECHNICAL DETAILS
INSTRUCTIONS FOR MOTORHOE ASSEMBLY
◊
LENGHT: 51 cm
◊
BL200/BL 250
HEIGHT: 70 cm