Dateq SPL 2 Mode D'emploi page 21

6 Installation
Connectors
To prevent modification of the connections after calibration and sealing, the connectors of the
limiter are unaccessible after sealing of the cover plates at the front. To access the
connectorboard, remove the right cover plate at the front panel.
Unfasten screw (A) with a torx-screwdriver (see illustration). Now remove the 4 torx-screws (B)
from the top lid. The top cover can be removed now. Gently lift the frontside a little, and slowly shift
the lop lid to the rear. The connectorboard will become visible.
Mic Input (only use the original DATEQ-microphone) (XLR 3-pins female)
Pin Function
1 Ground
2 Audio +
3 Audio -
Audio In Left / Right (balanced XLR 3-pins female)
Pin Function
1 Ground
2 Audio +
3 Audio -
Audio Out Left / Right (balanced XLR 3-pins male)
Pin Function
1 Ground
2 Audio +
3 Audio -
SPL2(TS) and SPL3(TS) user manual EN
Type
A-GND
In
In
Type
A-GND
In
In
Type
A-GND
Out
Out