Publicité
PUMA_SPF_NON_EU_3.p65
Downloaded from:
http://www.usersmanualguide.com/
STATUS INDICATORS
Be sure to use only genuine SHARP
parts and supplies.
When the following indicators light up or blink on the operation panel or the following symbols appear in the
display, solve the problem immediately referring to both the table below and the relevant page.
Indication
Drum replacement
Steadily
required indicator
lit
w
Blinking
Steadily
TD cartridge replace-
lit
ment required indicator
s
Blinking
Blinking
Misfeed indicator
t
SPF misfeed indicator
Blinking
(AL-1220 only)
The paper tray indicator
is blinking.
„CH" is blinking in
the display.
n
„CH" is steadily lit in the
display.
„P" is blinking in
the display.
Q
A letter and a number
appear alternately.
DISPLAYING TOTAL NUMBER OF COPIES
Use the following procedure to display the total number
of copies.
1. Press the clear (
display to zero.
2. Press and hold down the clear (
key for approximately 5 seconds. The
total number of copies will appear in
two steps, each with three digits.
Example:
Total number of copies is 1,234.
3 – 32
32
Cause and remedy
Replacement of drum cartridge will be needed soon. Prepare a
new cartridge. p. 3-23
Drum cartridge must be replaced. Replace it with a new one.
p. 3-23
Replacement of TD cartridge will be needed soon. Prepare a
new cartridge. p. 3-21
TD cartridge must be replaced. Replace it with a new one.
p. 3-21
A misfeed has occurred. Remove the misfed paper referring to
the description of „Misfeed removal." p. 3-26. Lever of fusing
area is not raised. p. 3-27
An original misfeed has occurred in the SPF. Remove the misfed
originals referring to the description of "Misfeed in the SPF".
p. 3-29.
The paper tray is not installed properly. Push the tray into the
copier securely. p.3-8.
The TD cartridge is not installed. Check if the cartridge is instal-
led. p. 3-7
Side cover is open. Close the side cover securely by pressing
the round projections near the side cover open button. p. 3-7
Paper tray or bypass tray (AL-1200, AL-1220) is empty. Load
copy paper. p. 3-8
A misfeed has occurred in the paper tray or bypass tray (AL-
1200, AL-1220). Remove the misfed paper. p. 3-27
Paper tray is not securely installed. Push the tray in securely.
p. 3-10
The copier will not function. Turn the power switch off, remove
the power cord from the outlet, and contact your authorized
Service representative.
>
) key to reset the
>
)
01/12/98, 08:57
Publicité
Chapitres
