Télécharger Imprimer la page

Automatic Exposure Adjustment - Sharp AL-1000 Mode D'emploi

Masquer les pouces Voir aussi pour AL-1000:

Publicité

PUMA_SPF_NON_EU_3.p65
Downloaded from:
http://www.usersmanualguide.com/

AUTOMATIC EXPOSURE ADJUSTMENT

AUTOMATISCHE BELICHTUNGSKORREKTUR
The automatic exposure level can be adjusted to suit
your copying needs.
1. Press the exposure mode selector
key to select the photo (
2. Press and hold down the exposure
mode selector key for approximately
5 seconds.
The photo (
and the AUTO indicator will begin to
blink. One or two exposure indicators
corresponding to the automatic expo-
sure level which has been selected
will light up.
3. Press the light (
lighten or darken the automatic expo-
sure level as desired.
If exposure level 2 is selected, the two
left-handmost indicators for that level
will light up simultaneously. Also, if
level 4 is selected, the two right-hand-
most indicators for that level will light
up simultaneously.
4. Press the exposure selector key. The
AUTO indicator will stop blinking and
light up steadily.
13
Die automatische Belichtungskorrektur kann Ihren
Kopieranforderungen gemäß eingestellt werden.
1. Die Wahltaste für den Belichtungs-
) mode.
2. Die Wahltaste für den Belichtungs-
) indicator will go out
{
}
) or dark (
) key to
3. Die Taste Hell (
4. Die Wahltaste für den Belichtungs-
• This automatic exposure lev-
el will remain in effect until you
change it again by this proce-
dure.
modus drücken und den Photo-Mo-
dus (
) wählen.
modus etwa fünf Sekunden lang ge-
drückt halten. Die Photo-Anzeige
(
) erlischt, und die AUTO-Anzeige
beginnt zu blinken. Eine oder zwei der
Belichtungsanzeigen leuchten auf, je
nach der gewählten Einstellung der
Belichtungsautomatik.
{
}
) oder Dunkel (
drücken, um die gewünschte Belich-
tungsautomatik einzustellen.
Wurde die Belichtungsstärke 2 ge-
wählt, leuchten die beiden linken äu-
ßeren Anzeigelämpchen gleichzeitig
auf. Bei Auswahl von Belichtungs-
stärke 4 leuchten die beiden rechten
äußeren Anzeigelämpchen gleichzei-
tig auf.
modus drücken. Die AUTO-Anzeige
blinkt nun nicht mehr, sondern leuch-
tet ständig.
• Diese Einstellung der auto-
matischen Belichtung bleibt so
lange bestehen, bis sie durch
die oben genannten Schritte
erneut verändert wird.
3 – 13
09/11/98, 10:51
)

Publicité

loading

Ce manuel est également adapté pour:

Al-1200Al-1220