Symbols - ChoiceMMed MDTS100 Manuel D'instructions

Stimulation is
weak or not
existent
Skin turns red
Skin feels numb
Device does not
turn on
Pads are not
sticky

19 Symbols

Type BF applied part
Serial number
Storage temperature and
humidity
Date of manufacture
Enclosure protection
degree
Mode 2
Mode 4
Mode 6
Are the electrode pads in close
contact with the skin?
Are the electrode pads touching
each other?
Are the wires connected to the
electrode pads and the main
device properly?
Are the batteries dead?
Did you stay with stimulation too
long?
Are electrode pads dirty?
Do the electrode pads touch the
skin closely?
Are the batteries installed
correctly?
Pads will deteriorate after multiple
uses.
Remove, clean and place back on
the skin.
If so, separate the pads.
Disconnect, clean and reconnect
all the parts.
Replace the batteries.
Stop treatment or move to another
area.
Clean with damp cloth or replace.
Remove and place again on the
skin.
Remove and install batteries.
Replace them with ChoiceMMed
Self-Adhesive Replacement Gel
Pads MDPS100
Attention, consult
accompanying document
Caution
"+"/"-" on the battery means
Positive/Negative Pole.
Please match the plus (+)
and minus signs in the
compartment
Manufacturer information
Mode 1
Mode 3
Mode 5
Mode 7
15