ChoiceMMed MDTS100 Manuel D'instructions page 13

Step 2- Connect the electrode pads to the wires
and then connect the wires to the device.
Plug the connecting wires into the electrode pads.
Then connect the wires to the device's output
channels. The A and B output channels can be
used simultaneously or one at a time. Select
channel by pressing CHA Button.
NOTE: If you connect wires to both A and B
outputs, you must turn on both A and B and have
pads connected. These pads MUST be placed on
the body for stimulation to occur.
Step 3- Put the electrode pads on the
stimulation –needed body area.
In order to achieve the best relief results. Place the
electrode pads around or on the top of your painful
areas. If possible, always use all the 4 electrode
pads at the same time. (If all 4 pads are being
used, both outputs must be turned on). Electrode
pads should be placed between 0.5"to 1.5"apart
from each other based on the relief area. Make
sure the pads stick firmly on the skin. Do not move
or remove the pads when the device is on.
Clean your skin before each use. Make sure your
skin is clean, dry and free from lotion before placing
the electrode pads on your skin.
Step 4- Press the ON/OFF button once to turn
the unit on
The LCD display will show 7 stimulation modes.
Step 5- Choose the output channel(s) to be
used for stimulation
Pressing the CHA button on the front of the unit
turn on and off the corresponding output channels.
(Both A&B are ON by default)
IMPORTANT: You must have wires inserted
into the output and pads placed on skin if the
output channel is turned on for stimulation to
occur. You can use one channel at a time or both
simultaneously as long as the output channel
is turned on, wires are connected and pads are
attached to skin.
11