Position For Use; Troubleshooting - ChoiceMMed MDTS100 Manuel D'instructions

be replaced when their adhesiveness becomes weak. To insure proper use, The applied Self
Adhesive Replacement Gel Pads should be used. Do not let the sticky side of the electrode
pads touch anything, including your fingertips. Do not use damaged or broken wires.
Dispose of battery properly; following any applicable local battery disposal laws.
The use life of the device is five years when it is used for 15 measurements every day and 20
minutes per one measurement.
Warning
• Water is prohibited in the host device, in order to avoid damaging the device or reducing
the safety and performance of the device.
• Please do not open the battery cover when the device is operated.
• Please do not clean and maintain the device when the device is operated.
• Please do not open the device enclosure, the device can only be maintained by personnel
authorized by the manufacturer.
• When the accessory of the device is damaged or failure, it must be the personnel
authorized by the manufacturers to replace the correct attachment.
• The host device should be cleaned at least once a month and can be cleaned by using
soft cloth dipped in small amount of water.
• The electrode pads can only be used by the single patient and the electrode pads is
required to be replaced periodically.
• Check the insulation of the output cable regularly, if there is any damage the cable should
be replaced immediately.
• When the battery is exhausted, the new battery should be replaced according to the
specification immediately.

17 Position for Use

Note:
1. The electrode pads should be applied firmly on the either side of the area where you feel the
pain.
2. Never apply electrodes on the throat or both sides of the neck,where the carotid sinus nerves
are located.

18 Troubleshooting

If your device is not operating properly, please check it for the following problems or conditions.
If the recommended action does not solve the problem, please return it to the Beijing Choice
Electronic Technology Co., Ltd for a replacement or repair of the device.
MALFUNCTION CAUSE SOLUTION
14