Unloading The Dishwasher; Care And Maintenance - Bosch SHE55C Guide D'entretien Et D'utilisation

Sanitation Foundation (NSF). For more information on NSF certification, refer to the Wash
Cycle information section of this manual.

Unloading the Dishwasher

Unload the bottom rack first.
unload the silverware basket(s). they are easily removed for unloading.
unload the top rack.
if the extra tall item sprinkler was installed, return the dishwasher to its normal condition
(see the Loading Extra Tall Items instructions in the "Loading the Dishwasher" section of this
manual).

Care and Maintenance

Maintenance Tasks
Certain areas of your dishwasher require occasional maintenance. the maintenance tasks
are easy to do and will ensure continued superior performance from your dishwasher. these
tasks are:
• Winterizing Your Dishwasher
• Wiping up Spills and Splash-out
• Clean the Stainless Steel Inner Door and Tub
• Check/Clean the Spray Arm Nozzles
• Check/Clean the Filter System
• Clean the Exterior Door Panel
• Clean the Door Gasket
Winterizing Your Dishwasher
if your dishwasher will be unused for an extended period of time in a location that experiences
freezing temperatures (e.g., in a holiday home or through a vacation period), have your
dishwasher winterized by an authorized service center.
NOTICE
To avoid dishwasher damage, do not allow water to remain in your dishwasher systems
through extended periods of freezing temperatures. Freezing temperatures can dam-
age your dishwasher.
Wiping Up Spills and Splash-out
Water may occasionally splash out of your dishwasher, especially if you interrupt a cycle or
open the dishwasher door during a cycle. To avoid floor damage and possible mold growth,
do not allow wet areas to remain around or under the dishwasher.
Check/Clean the Stainless Steel Inner Door and Tub
Clean the outer edges of the inside door panel regularly to remove debris that might collect
there from normal loading.
if spots begin to appear on the stainless steel tub or inner door, make sure the rinse agent
reservoir is full.
Check/Clean the Spray Arm Nozzles
occasionally check the spray arms to ensure that the spray arm nozzles (holes) are unobstructed.
You must remove the spray arms to check them for obstruction.
14
Figure 23