Footswitch Battery - Chauvet DJ 4BAR Flex Q Manuel De Référence

Wireless Footswitch Operation
The included wireless footswitch provides quick access to preset colors, color-change programs, and sound-activation
through the 4BAR Flex Q microphone.
Power
switch
LED
indicators
To use the footswitch:
1. Connect the 4BAR Flex Q to power. Turn the wireless footswitch on.
2. Press <MENU> repeatedly until SEt shows on the display, and press <ENTER>.
3. Use <UP> or <DOWN> to select ir, and press <ENTER>.
4. Use <UP> or <DOWN> to select on, and press <ENTER>.
5. Press <MENU> repeatedly until P-- shows on the display, and press <ENTER>.
6. Press pedal #3 to activate static color controls. When working, all the lights will begin in a static color and Foot
will appear on the menu display.
7. Use the chart below to activate the desired function.
Pedal Action
Tap pedal to
1
activate, then tap
(Auto
to navigate to
program)
desired function
2
Press and hold
(Sound mode)
3
(Static colors)
The 4BAR Flex Q footswitch will work properly in any mode, with a maximum unobstructed
distance of 100 ft (30.5 m). You must turn on the ir setting from the 4BAR Flex Q and navigate to
Auto mode before using the footswitch.

Footswitch Battery

The wireless footswitch uses a 9-volt battery located under the battery cover on the bottom of the product, which can be
replaced when necessary.
Battery replacement
To replace the battery in the wireless footswitch:
1. Turn the power switch to the Off position.
2. Remove the battery cover by removing 2 screws with a Phillips-head screwdriver.
3. Remove the old battery from the housing and unplug it from the leads.
4. Replace with a new 9-volt battery, ensuring that the positive (+) and negative (-) leads correspond to the correct
electrodes on the battery.
5. Place the battery into the housing and cover with the battery cover.
6. Secure the battery cover with the 2 Phillips-head screws.
DO NOT over-tighten the screws!
4BAR Flex Q USB QRG Rev. 2
QUICK REFERENCE GUIDE
4
3
2
Function
Auto programs 1–8
Sound-active
programs
Red, green, blue, and
amber
Red
Green
Blue
Tap
Amber
Red and green
Red and blue
Red and amber
Green and blue
1
Pedal
3
(Static colors,
cont.)
4
(Blackout)
Action Function
Green and amber
Blue and amber
Red, green, and blue
Red, green, and
amber
Red, blue, and amber
Tap
Green, blue, and
(cont.)
amber
3000K
4500K
5600K
Auto snap program
Auto fade program
Press and hold Auto fade program
Tap Blackout
Press and hold Fade to blackout
EN
9-volt battery
cover
4