Manual Operation; Electrical Operation - Chore-Time W400B1-CT Manuel D'utilisation

Isolate mains power before using the manual crank feature as shown below.
Use a 13mm (1/2 in) hex socket with a suitable drive bit (not included) to operate the winch manually.
Rotation of the socket will operate the winch in either direction.
In operation the winch will require the user to hold the controlling switch to raise or lower the load.
The winch should operate quietly with only the hum of the motor, and perhaps some pulley noise depending on the
condition and/or lubrication of the various pulleys connected to the load.
If the winch produces any abnormal noises such as grinding, rattling or squeaking, cease use immediately and isolate the
power. Refer to Troubleshooting on page 14, and/or contact a suitably qualified technician to inspect and/or repair.

MANUAL OPERATION

13mm or 1/2"
Hex Socket

ELECTRICAL OPERATION

NOTE: 13mm or 1/2"
Hex Socket is not
supplied with the winch
12