Safety And General Information; Specifications - Chore-Time W400B1-CT Manuel D'utilisation

CAUTION, WARNING AND DANGER DECALS
dangerous situations. Care should be taken to keep this information intact and easy to read at all times. Replace missing or
damaged safety decals immediately.
SAFETY–ALERT SYMBOL
THIS IS A SAFETY–ALERT SYMBOL.
potential for personal injury. This equipment is designed to be installed and operated as safely as possible...
however, hazards do exist.
Understanding Signal Words
Signal words are used in conjunction with the safety–alert symbol to identify the severity of the warning.
DANGER indicates an imminently hazardous situation which, if not avoided,
WILL result in death or serious injury.
WARNING indicates a potentially hazardous situation which, if not avoided,
COULD result in death or serious injury.
CAUTION indicates a hazardous situation which, if not avoided,
MAY result in minor or moderate injury.
FOLLOW SAFETY INSTRUCTIONS
Carefully read all safety messages in this manual and on your equipment safety signs. Follow recommended precautions
and safe operating practices.
Keep safety signs in good condition. Replace missing or damaged safety signs.
Direct Drive Belt Winch General Specification
Lift Capacity Max. (lbs)
Max Lift Speed (ft/min)
Drum Torque (ft-lbs)
Drum Diameter (inch)
Maximum Lift Height (ft)
Belt Size (mm x mm)
Mounting Bolt Spec
Limits
IP Code
Manual Operation
Weight (lbs)
Suitable Controller
Operating Temperature
Application

SAFETY AND GENERAL INFORMATION

SPECIFICATIONS

885
~10.1
177
2.62 (min) 5.5 (Max)
12.8
40 X 1.5
4 X M12 HT
2 X NC Micro Switch
IP55
USE 13mm Socket
73
Single Phase
RG37612P-CT Wall Control
(sep. avail.) CTB Ref: 56930
Three Phase
RG37812P-CT Wall Control
(sep. avail.) CTB Ref: 57085
10°C - 40°C / 50°F - 104°F
Indoor use only
have been placed on the equipment to warn of potentially
When you see this symbol on your equipment, be alert to the
Single Phase Electrical Specification
Motor Power
Full Load Current
Voltage
Phase
Frequency
Capacitor( Uf)
Motor Fuse
Three Phase Electrical Specification
Motor Power
Full Load Current
Voltage
Phase
Frequency
4
1.5Hp, 1.1kW
7.1 Amp
230V
1 (2 X Hot Wire)
60Hz
Run-35 / Start 200
12 Amp Slow Blow
1.5Hp, 1.1kW
5.5 Amp
230V 3-Phase
3
60Hz