Chore-Time W400B1-CT Manuel D'utilisation page 8

FLAG MOUNTING
Mount the Belt winch in flag configuration using at least 2 x M12
High Tensile (Grade 8.8) bolts and locking nuts to secure the
winch to a suitably engineered vertical or horizontal structural
member as shown below. Tighten to a torque of 40-45Nm.
(Note: Fasteners are not supplied). Weld fixing may be suitable if
carried out in accordance with proper structural advice and by a
suitably qualified person.
MOUNTING
8
An electrician must disconnect electric
power to the winch and control before
removing or opening covers.