Specifications; Operation; Troubleshooting - Chore-Time 56930 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

56930 SPECIFICATIONS

Full Load Current
Voltage
Phase
Frequency
Suitable Operator
Ingress Protection
Application

OPERATION

This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruc-tion concerning use of the appliance by a person responsible for their safety. Children should be
supervised to ensure that they do not play with the appliance.
The winch must be set up according to the setup procedure prior to operation..
To operate the winch using the controller
Press and hold the UP button on the controller to raise using the winch
Release the UP button to stop the winch at any position.
Press and hold DOWN to lower using the winch.
Release the DOWN button to stop the winch at any position.

TROUBLESHOOTING

The winch does not raise or lower
• Does the controller have power? Check the isolator switch
and circuit breaker.
• Check the motor has the correct power supply and
voltages.
• Has the overload tripped? Isolate power to the control box
and check the overload reset.
• Has the motor overheated? Allow the motor to cool.
• Has the motor seized? Use the hand crank to check the
operation of the winch and motor.
• Check the limits have been set correctly. Excess wires
crammed into the enclosure can affect the operation of the
limit switches.
SPECIFICATIONS & OPERATION
7.1 Amp
230V
Single Phase (2 x Hot Wire)
60Hz
1.1kW (1.5Hp) Single Phase 5-Wire
IP55
Indoor use only
0.24in
4 -
6mm
4.86in
123.5mm
6.00in
152.5mm
0.77in
3 -
19.5mm
7
123.5mm
152.5mm
3 -
The winch only drives in one
direction
• Have the limits been set correctly?
Check limit switch wiring and
adjustment. Excess wires
crammed into the en-closure can
affect the operation of the limit
switches.
• Check single phase motor
connections.
• Check the motor has the correct
power supply and voltages.
0.24in
4 -
6mm
4.86in
6.00in
0.77in
19.5mm
UP
STOP
DOWN

Publicité

Table des Matières
loading

Table des Matières