Pre-Set Leg Rests And Footplates (Sedeo Pro Advanced Up); Pre-Set Lower Leg Length; Depth Adjustment Of The Knee Fixation; Width Adjustment Of The Knee Fixation - Sunrise Medical QUICKIE Sedeo Pro Advanced Manuel D'utilisation

4.6 Pre-set Leg Rests and footplates (Sedeo Pro Advanced UP)

4.6.1 Pre-set lower leg length (Fig 4.17):
• Loosen bolts and take them out (2x bottom ones) at both sides of
the footplates. (C).
• Put footplates in desired position.
• Tighten bolts (2x bottom ones). (C).
Pre-set footplates individually (Fig 4.18):
They height of the footplates can be individually set by:
• Loosen 4 bolts (A)
• Turn screw B (fig 4.16) to adjust footplate height.
• Tighten 4 bolts (A)
4.6.2 Depth adjustment of the knee fixation (Fig. 4.19 - 4.20):
The depth of the kneepads can be adjusted by turning the knob (D).
4.6.3 Width adjustment of the knee fixation (Fig. 4.19 - 4.20):
• Loosen bolts (E).
• Put kneepads in desired position.
• Tighten bolts (E).
4.6.4 Height adjustment of the knee fixation (Fig. 4.19 - 4.20):
2 ways:
Adjust position of knee fixation receiver (2 positions).
• Loosen bolts (4x). (F).
• Put knee fixation receiver in desired position.
• Tighten bolts (4x). (F).
Flip around the kneepads (2 positions). These are mounted off-centred
→ 2 positions.
• Loosen bolts (E).
• Flip the kneepads around.
• Tighten bolts (E).
Sedeo Pro Advanced/Advanced UP Rev.A
C
A
D
E
F
Fig. 4.17
B
Fig. 4.18
Fig. 4.19
Fig. 4.20
E
F
15