4.4 Preset Leg Rests and foot plates (Sedeo Ergo UP)
4.4.1 Pre-set lower leg length (Fig 4.10):
• Loosen bolts and take them out (2x bottom ones) at both sides of
the foot plates. (C).
• Put footplates in desired position.
• Tighten bolts (2x bottom ones). (C).
Pre-set footplates individually (Fig 4.11):
They height of the footplates can be individually set by:
• Loosen 4 bolts (A)
• Turn screw B (fig 4.10) to adjust footplate height.
• Tighten 4 bolts (A)
4.4.2 Depth adjustment of the knee fixation (Fig 4.12 - 4.13):
The depth of the knee-pads can be adjusted by turning the knob (D).
4.4.3 Width adjustment of the knee fixation (Fig 4.12 - 4.13):
• Loosen bolts (E).
• Put knee-pads in desired position.
• Tighten bolts (E).
4.4.4 Height adjustment of the knee fixation (Fig 4.12 - 4.13):
2 ways:
Adjust position of knee fixation receiver (2 positions).
• Loosen bolts (4x). (F).
• Put knee fixation receiver in desired position.
• Tighten bolts (4x). (F).
Flip around the knee-pads (2 positions). These are mounted off-
centered → 2 positions.
• Loosen bolts (E).
• Flip the knee pads around.
• Tighten bolts (E).
Sedeo Ergo Rev.1.0
C
A
D
E
F
B
Fig. 4.10
Fig. 4.11
Fig. 4.12
E
F
Fig. 4.13
11