5.2 Stand Up Functions (Q700-UP M)
WARNING!
• The chest strap may only be assembled and adapted by an
authorized dealer.
• Before operating the stand-up function the chest strap and
the positioning belt, supplied as standard has to be buckled in
accordance with these user instructions.
• Always also use the knee fixation for the stand-up procedure.
DANGER!
Due to the risk of choking it is extremely hazardous to use the
belts without using the knee fixation.
5.2.1 Chest strap Adjustments:
Setting the height of the chest strap, (Fig.5.8).
NOTE: A 5.0 mm Hexagon wrench, (Allen Key), is required.
Positioning:
• Seat the user into the chair in the correct seating position.
• Loosen the Allen screw to be able to position the chest strap at
the desired height.
• Tighten the Allen screws to a torque value of 9 Nm (+/- 10%).
DANGER!
• To prevent choking hazards the belt may not be adjusted too
high or too low relative to the users body.
• Make sure the rider does not slide in the wheelchair seat. If this
occurs, the rider may suffer chest compression or suffocate due
to pressure from the chest strap.
• Never use the chest strap as a patient restraint.
• Never use the chest strap on a user who is comatose or
agitated.
CAUTION!
Ensure the belt position does not interfere with any other device
attached to the wheelchair.
16
Fig.5.8
Sedeo Ergo Rev.1.0